Skip to content

Switching on the device

Once the MEISTERSTÜCK 3 is connected to the power supply, you can switch it on.

Switch on the power switch on the rear

1. Switch on the power switch

Set the power switch on the rear of the MEISTERSTÜCK 3 to position I.

Remove the protective film from the MEISTERSTÜCK 3 display

2. Removing the protective film

Carefully peel the protective film off the MEISTERSTÜCK 3 display.

Press the standby button on the MEISTERSTÜCK 3

3. Switching on the device

Press the standby button to switch on the MEISTERSTÜCK 3.

After switching on, the MEISTERSTÜCK 3 automatically starts the initial setup.
The first startup may take a few seconds.