Skip to content

Connecting the power supply

Connect the sonoro AMPLIFIER to the mains to put the device into operation.

Before connecting, read the information under General safety instructions.

Connecting the power cable to the sonoro AMPLIFIER

1. Connect the power cable

Connect the power cable to the power socket on the rear of the sonoro AMPLIFIER.

Connecting the power cable to the socket

2. Connect to power

Then insert the mains plug into an easily accessible socket.

ℹ Use only a suitable AC power supply of 100–240 V AC, 50/60 Hz.
ℹ Make sure the power cable is not kinked, trapped or subjected to excessive strain.
ℹ The socket should be as close to the device as possible and freely accessible at all times, so that the device can be quickly disconnected from the mains if necessary.
ℹ When using multi-socket outlets, observe their technical specifications and ensure that the total power of all connected devices does not exceed the outlet’s maximum permissible load. Also follow the power supply information in the General safety instructions.